Page 2 of 2

Re: Install problem

Posted: Fri Mar 12, 2010 8:14 pm
by Eugene
Hi,
markjen73 wrote: changed device to PS3 1920x1080 and tried using Flac-LPCM profile, no luck. Switched transcode to mp3 with profile Music-Primary and it works! Plays both .flac and mp3 files.

Now my question is...do I load all my 5300+ files all at once? Does WMS go through the whole library and transcode everything or does it only transcode the one that is playing? Just afraid that throwing all those files at it at once will make it hang. Suggestions?
Settings - Transcoder - Profiles - "Music - FLAC - LPCM" - Edit
Mime-type: audio/mpeg
Transcoding parameters:

Code: Select all

-i "<INPUT FILE>" -f mp3 -acodec libmp3lame -ab 320000 -ar 48000
Language: None script

Re: Install problem

Posted: Sat Mar 13, 2010 1:39 am
by markjen73
The Transcoding Parameters window is full of code. Do I delete all that code and paste in: -i "<INPUT FILE>" -f mp3 -acodec libmp3lame -ab 320000 -ar 48000? Or do I append it on to the end, the beginning or what?

By the way, tried scanning all 5300 media files again and WMS became "not responding".

thanks,

Mark

Re: Install problem

Posted: Thu Mar 18, 2010 6:28 am
by markjen73
Bump?

Re: Install problem

Posted: Thu Mar 18, 2010 7:09 pm
by markjen73
Hello? Eugene?

Re: Install problem

Posted: Thu Mar 18, 2010 7:14 pm
by Eugene

Re: Install problem

Posted: Fri Mar 19, 2010 6:22 am
by markjen73
Not sure what you're saying. Do you not want to help me? I can go elsewhere if that's what you're suggesting... guess this is how you get people to buy your software when the trial is over?

Did you read my post? I asked where to put the code in the transcoding parameters window.

Grumpy.

Re: Install problem

Posted: Fri Mar 19, 2010 7:13 am
by Eugene
markjen73 wrote:Not sure what you're saying. Do you not want to help me? I can go elsewhere if that's what you're suggesting... guess this is how you get people to buy your software when the trial is over?

Did you read my post? I asked where to put the code in the transcoding parameters window.
I think this program is too complicated for you, perhaps in the future it will be easier for you, good luck.